31
6 Using the System
6.4 Status Monitoring and Operation Screens
6.4.1 Displaying general information by tenant
Use this screen to display information about all connected indoor units by tenant.
Procedure
Select 1.Status/Control in the main menu and 1.Each tenant in the sub menu.
The indoor units for each tenant are displayed.
Tenant name
1.Status/Control
2.Total data/Cut-off
3.Distrib. ratio/Usage
4.Maintenance/Test Run
5.Initial settings
6.Auxiliary settings
1.Each tenant
2.Each tenant details
3.Each zone
4.Each zone details
5.All units
1
Scrolls the display one tenant at a time.
2
Scrolls the display one row at a time.
Meaning of symbols
: COOL
: SWING
: DRY
: TIMER
: FAN
: Clean filter sign
: HEAT
: VENTILATION
: ALARM
: AUTO Mode/Speed
: High fan speed
: Medium fan speed : Low fan speed
: Accept remote controller : Prohibit remote controller setting No.1
“---” is displayed in the tenant name row for indoor units not registered to a tenant.
The fi rst 12 characters are displayed for tenant names and unit names.
If an Interface Adaptor is used, the color becomes light purple during the ON operation.
Main
Sub
1
1
CZ-256ESMC2_EN.indb 31CZ-256ESMC2_EN.indb 31 9/14/2011 3:16:49 PM9/14/2011 3:16:49 PM
To Next Page
Loading...
