Panasonic CZ-256ESMC2

32
6 Using the System
6.4.1.1 Operating units individually
Use this screen to operate individual indoor units.
Procedure
Select 1.Status/Control in the main menu and 1.Each tenant in the sub menu.
1
When you touch the unit that you want to set, a remote control window for individual on/off
operations appears.
2
When you touch
, a remote control window appears. This window allows you to
make detailed settings for operations on individual units.
a
b
d
e
f
g
i
j
k
l
c
h
1.Status/Control
2.Total data/Cut-off
3.Distrib. ratio/Usage
4.Maintenance/Test Run
5.Initial settings
6.Auxiliary settings
1.Each tenant
2.Each tenant details
3.Each zone
4.Each zone details
5.All units
Move the display position on the
screen up and down one line.
•
For multiple units, the operation mode for one unit may not be varied while another indoor unit is under
operation. In such a case, once stop the unit, hold it for several minutes, and then vary the operation
mode.
•
In the remote control window, the fi rst 16 characters for tenant names and the fi rst 12 characters for unit
names are displayed.
Main
Sub
1
1
1
1
a. Closes the remote control window.
b. Sets to either Start or Stop.
c. Sets the operating mode.
d. Set the temperature.
e. Sets the fan speed.
f. Sets the fan direction. This setting is applied to
the entire group. You cannot change the sub
unit setting independently.
g. Sets and cancels timer operation.
h. Sets timer number from No. 1 to No. 50.
i. Displays a window that allows you to check timer
setting status and remote control prohibition
status.
j. Displays one of “Prhbt1/ Prhbt2/ Prhbt3/ Prhbt4/
Accept”.
k. Turns the ventilation function ON and OFF. (You
cannot press the button when air conditioners
have no ventilation functions).
l. Resets fi lter cleaning signs.
CZ-256ESMC2_EN.indb 32CZ-256ESMC2_EN.indb 32 9/14/2011 3:16:50 PM9/14/2011 3:16:50 PM