Panasonic CZ-256ESMC2

64
6 Using the System
6.8.8 Indoor unit settings
You can use this screen to check the air conditioning capacity of indoor units, and to set the capacity.
Normally you do not need to change settings with this screen.
Exercise care when changing settings, because improper settings can prevent accurate
distribution.
Procedure
Select 6.Auxiliary settings in the main menu and 8.I/D unit settings in the sub menu.
*When “No Distrib.” is selected, this screen is not accessible. (see
Main
Sub
1
1
5
5
)
1
Select the link system to display.
1
3
4
2
1.Status/Control
2.Total data/Cut-off
3.Distrib. ratio/Usage
4.Maintenance/Test Run
5.Initial settings
6.Auxiliary settings
1.Zone name
2.ZoneNo./Mng.target
3.Program timer
4.Ten.Ho/TimerSp.Day
5.Prohibit R/C
6.Distribution time zone
7.Special distrib. day
8.I/D unit settings
10.WEB settings
11.User settings
9.Other settings
2
To change a capacity setting, touch an item in the capacity column, and enter a kW capacity
from 0 to 999.9 in the numeric keypad window which appears.
3
Touch Set to confi rm the setting.
Or Auto to cancel it. (The capacity value will restore the received level)
If you have changed the capacity, an asterisk (
∗
) appears to the left of the value.
4
Touching the heater capacity column for the indoor unit having an electric heater will have a soft
ten-key for the heater capacity setting displayed. Input numbers 0.0 to 100.00 by kW. However,
these are effective only for loaded distribution settings.
Main
Sub
6
6
8
8
CZ-256ESMC2_EN.indb 64CZ-256ESMC2_EN.indb 64 9/14/2011 3:17:09 PM9/14/2011 3:17:09 PM