Panasonic CZ-256ESMC2

62
6 Using the System
6.8.6 Setting distribution time zones
You can set distribution time zones for the same day of each week.
Procedure
Select 6.Auxiliary settings in the main menu and 6.Distribution time zone in the sub menu.
*When “No Distrib.” is selected, this screen is not accessible. (see
Main
Sub
1
1
5
5
)
1.Status/Control
2.Total data/Cut-off
3.Distrib. ratio/Usage
4.Maintenance/Test Run
5.Initial settings
6.Auxiliary settings
1.Zone name
2.ZoneNo./Mng.target
3.Program timer
4.Ten.Ho/TimerSp.Day
5.Prohibit R/C
6.Distribution time zone
7.Special distrib. day
8.I/D unit settings
10.WEB settings
11.User settings
9.Other settings
1
3
7
5
2
1
Select the distribution group.
2
Touch the “From” column.
3
Set the start time of regular hours to a time between 00:00 and 24:00 (30-minute intervals).
4
Touch the Set button to confi rm the setting, or the Cancel button to cancel it.
•
If you set the start time to 00:00 and the end time to 24:00, the entire day is regular hours.
•
If the start time is the same as the end time, the entire day is out of hours.
•
If the start time and the end time are reversed, the outer side is regular hours.
5
Touch the “To” column.
6
Set the end time of regular hours to a time between 00:00 and 24:00 (30-minute intervals).
7
Touch the Set or Cancel button.
* Refer also to “6.6.3 Time zone totals and distribution”.
Main
Sub
6
6
6
6
CZ-256ESMC2_EN.indb 62CZ-256ESMC2_EN.indb 62 9/14/2011 3:17:07 PM9/14/2011 3:17:07 PM