66
RQT8851
When Other Panasonic Products
Respond to this Remote Control
Use this function to synchronize the codes for the
remote control and the main unit when there are other
Panasonic products close to your unit.
With the unit stopped
e, r to select “Setup”, then q.
e, r to select “Remote Control
Code”, then
e, r
to select the code “Set Code1”, “Set
Code2”, or “Set Code3”, then
to set.
While pressing and holding ,
press and hold the numbered
button , , or
corresponding to the code set in
step 4 for more than 5 seconds to
set.
to complete.
When the following indicator appears on the unit’s display
Change the code on the remote control to match the
code displayed for the main unit (➔ step 5).
–
Tips
To return to the previous screen
Press [RETURN].
To exit the screen
Press [SETUP].
To Reset this Unit
To reset the channel information and the
clock settings
On the main unit
Press and hold both buttons
for about 5 seconds.
To reset the ratings level settings
You can reset both parental rating (➔ 42) and
DVD-Video rating (➔ 38).
With the unit stopped
to open the disc tray.
On the main unit
REC
Press and hold
both buttons for
about 5 seconds.
To restore the unit if it freezes
On the main unit
Press and hold for more
than 10 seconds.
The unit is off.–
or
On the main unit
REC
Press and hold for
more than 1 second
with a pointed object.
If the Antenna Connector doesn’t Match
Use one of the following connections to suit the antenna lead to the unit’s RF IN terminal, and the 75 Ω coaxial
cable to the antenna terminals on your TV or other equipment. Refer to the other equipment’s operating instructions
for more information.
Type This unit Other equipment (television etc.)
A twin lead
from the antenna
(Flat) Twin lead
300 Ω cable
300−75 Ω transformer
To this unit’s RF IN
terminal
75−300 Ω transformer
75 Ω coaxial
cable
VHF or UHF
Television
Troubleshooting Guide
To Next Page
Loading...
Need help?
General
