36
Timer recording (continued)
To check programmes
Press [PROG/CHECK] (13).
The Timer Programme List screen appears.
Icon explanations (A)
¥ This programme is currently recording.
W The programme is overlapped with another programme.
F The disc was full or the maximum number of programmes or
scenes was reached so the programme failed to record.
The television programme was copy-guarded so the
programme failed to record.
X The programme failed to record for some other reason.
Icon explanations (B)
Auto Renewal Recording indicator [HDD]
The programme will be automatically recorded over in
succession.
Relief Recording indicator
Programmes that have been rerouted to the HDD because
of insufficient remaining space.
Recording drive indicator :HDD
Recording drive indicator :DVD
Disc space
OK: Displayed if the recording can fit in the remaining
space on the disc. However, when the programme
becomes longer than scheduled during the
recording by setting “VPS/PDC” to “ON”, the
programme may not be recorded until its end.
# (Date): For recordings made daily or weekly, the display
will show until when recordings can be made
based on the time remaining on the disc.
!: Displayed if the disc is not inserted in the unit or is
write-protected (pages 39, 87) or there is no more
space left on both HDD and DVD-RAM/R.
ªTo change the programme
(page 34)
ªTo exit from the Timer Programme List screen
Press [PROG/CHECK] (13) or [RETURN] (23). (The television is
shown.)
For your reference
≥Programmes that failed to record are deleted from the list at 4
a.m. the day after tomorrow.
Starting and cancelling programmes
ªTo put the unit on recording standby
Press [Á, TIMER] (12).
The unit turns off and “Á” lights on the unit’s display.
Note
≥The unit cannot go to timer recording standby if the disc is
protected (pages 39, 87) or full (“Á” flashes). Check the disc
carefully.
ªTo release the unit from recording standby
If you want to record something else before the programme start
time, for example:
Press [Á, TIMER] (12).
The unit turns on and “Á” goes out.
≥Be sure to press [Á, TIMER] (12) before the programme start
time to put the unit on recording standby. The programme only
works if “Á” is on.
ªTo stop recording while a programme is working
Press [Á, TIMER] (12).
To clear a timer recording programme
Press [CANCEL] (5) or [ERASE] (30) while the programme’s
Timer Programme Correction screen is being shown.
Alternatively, use [3, 4] (10) to select the programme in the
Timer Programme List screen and press [CANCEL] (5) or
[ERASE] (30).
≥You can not delete programmes that are currently recording.
RETURN
SELECT
TIMER
RECORDING
ENTER
CANCEL
35:39 LP
Remain
HDD DVD
4:00 LP
SP
OK
21:0020:001 ARD 16/ 7 TUE01
Mode
Disc
space
StopStartNo.
Name
Date
New Timer Programme
---
VPS
PDC
HDD
DVD
LP22:0020:305 BR3 MON-FRI02
ON
FR21:3019:002 ZDF 19/ 7 FRI
9/8
03
ON
LP19:0017:001 ARD 20/ 7 SAT04
---
SP22:3020:002 ZDF 21/ 7 SUN05
---
OK
OK
OK
W
F
X
A
B
16. 7 TUE19:30:00
DVD(PAL).book36ページ２００３年５月１３日 火曜日 午後１２時３分
To Next Page
Loading...
Need help?
General
