EasyManua.ls Logo

Panasonic DMR-HS2 - Erasing Parts of a Programme; Erasing Multiple Programme Parts

Panasonic DMR-HS2
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
Using the DIRECT NAVIGATOR (continued)
Erasing parts of a programme
[HDD] [RAM]
The specified parts of the programme are erased completely
when you use this procedure and cannot be retrieved.
Check the programme carefully to ensure it isn’t one you want
to keep.
Preparation
Switch [DVD, TV] (15) to “DVD”.
For the HDD:
Confirm that something has been recorded on the HDD.
For the disc:
Insert a disc that has been recorded on.
1 Press [HDD] or [DVD] (6) to select the playback
drive.
(page 18)
2 Press [DIRECT NAVIGATOR] (9).
3 Use [3, 4] (10) to select the programme which
contains the part you want to erase.
4 Use [1] (10) so the submenu appears.
5 Use [3, 4] (10) to select “Partial Erase” and press
[ENTER]
(10).
6 Use search functions such as fast-forward and
slow-motion to find the start point of the part you
want to erase and press [ENTER] (10).
(a) Current programme number
7 Use search functions such as fast-forward and
slow-motion to find the end point of the part you
want to erase and press [ENTER] (10).
8 Use [3, 4] (10) to select “Exit” and press [ENTER]
(10).
9 Use [2] (10) to select “Erase” and press [ENTER]
(10).
Play lists created with the erased part are also erased.
ªTo stop partway through
Select “Cancel” in step 9 and press [ENTER] (10).
Or
Press [RETURN] (23).
ªTo erase another part of the same programme
After storing the point in “Start” and “End”, select “Next” in step 8
and perform step 9, then repeat steps 6-9.
For your reference
Use search and slow-motion to find the points.
You cannot specify an end point before a start point or a start
point after an end point.
You may not be able to specify start and end points within
3 seconds of each other.
You cannot specify start and end points if the picture recorded is
stilled.
The unit pauses play when the end of the programme is reached
during this procedure.
The disc’s available recording time may not increase after
erasing short parts of programmes.
Play lists created with the erased part are also erased.
Enter Title
Properties
Protection
Partial Erase
Erase
Divide
Partial
Erase
0 : 00 . 05
Start
– : – – . – –
End
3
Start
End
Next
Exit
0 : 00 . 05
PLAY
003
RETURN
ENTER
SELECT
HDD
(a)
0 : 00 . 05
Start End
3
Start
End
Next
Exit
0 : 10 . 15
RETURN
ENTER
SELECT
0 : 10 . 15
003
3
Partial
Erase
HDD
0:19 SP
Remaining Time
Partial Erase
Corresponding PLAY LIST will also be erased.
Erase Cancel
RETURN
ENTER
SELECT
DVD(PAL).book46ページ2003年5月13日 火曜日 午後12時3分

Table of Contents

Related product manuals