With a printer (PictBridge)
6 Select the date print setting on [l]g DATE PRINT].
• If the printer isnot capable of date printing, this setting is unavailable.
o
£
L.
7 Select the paper size setting on [E_ PAPER SIZE].
STANDARD: Size specific to the printer
4X5 INCH: L size
5X7 INCH: 2L size
4X6 INCH: Postcard size
A4: A4 size
• You cannot set paper sizes not supported on the printer.
8 Select the layout setting on [_ PAGE LAYOUT].
STANDARD: Layout specific to the printer
B : No frame print
: Frame print
• You cannot set page layouts not supported on the printer.
9 Select [_ PRINT] --_ [YES] and press the joystick.
The pictures are printed.
• Exit PictBridge by disconnecting the USB cable (supplied) after the
pictures have been printed.
When you stop printing halfway
Move the joystick down.
A confirmation message appears. If [YES] is selected, the number of prints set is canceled and the
screen returns to step 3. If [NO] is selected, all the settings are kept and the screen returns to
step 3.
• You may not be able to print stitt pictures recorded
with other products
• When the unit is connected directty to the printer,
the DPOF settings cannot be used
• Connect the printer directty to this unit. Do not use a
USB hub.
• Avoid the following operations during printing
These operations disable proper printing.
- Disconnecting the USB cable
- Removing the SD card
- Switching the mode dial
- Turning off the power
• Check the settings for the paper size, quaIity of
print, etc. on the printer.
• The sides of pictures recorded when [[_]
(VDR-D30O)/[[_] (VDR-D250) is set may be cut
at printing Check before printing
When using the printer with a trimming feature or
other feature which cuts out both edges of the
pictures, cancel the feature for printing. (Refer to the
operating instructions of the printer for details.)
110
LSQT1011
To Next Page
Loading...
