Using an SD card on a computer (Macintosh)
Using an SD card on a computer (Macintosh)
/_ Connect this unit to the AC adaptor.
_>lnsert an SD card with recorded images in the unit, turn on the unit and then
rotate the mode dial to select _.
1 Press the MENU button, then select [ J[_SETUP]
--_ [[] USB FUNCTION] --_ [PC CONNECT] and
press the joystick.
• Press the MENU button to exit the menu screen.
Connect this unit and a computer.
O USB cable (supplied)
• Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
icon appears.
• Do not use any other USB cables except the supplied
one. (Operation is not guaranteed with any other USB
cables.)
E
o
o
• When the unit is connected to a computer, the
operation mode cannot be changed and its
power cannot be turned off.
In this case, disconnect the USB cable (-). 141 )
• When a computer is accessing a card in this unit,
the card access Iamp lights. (_,'] appears on the
LCD monitor.) Do not disconnect the USB cable or
AC adaptor while the card is being accessed as it
may damage the data
140
LSQT1011
To Next Page
Loading...
