Panasonic DVD Palmcoder VDR-D250 - Setting Date and Time

Setting date and time
Setting date and time
When the unit is turned on for the first time, a message asking you to set the date and time will
appear.
• Select [YES] and press the joystick. Perform steps 2 and 3 below to set the date and time.
If the screen shows the incorrect date and time, then adjust it.
_ Rotate the mode dial to select _ or _.
1 Press the MENU button, then select [ I[ BASlC]--_
[Q CLOCK SET] --_ [YES] and press the joystick.
Move the joystick left or right to select the item to
be set. Then, move the joystick up or down to set
the desired value.
• The year will change as follows:
2000, 2001 ..... 2099, 2000 ....
• The !2-hour system is used to display the time.
Press the joystick to enter the selection.
• After pressing the MENU button to finish the setting, check the date and time display.
• The clock function starts at [00] seconds.
Q.
LSQT1011