Using discs on a computer (Macintosh)
12 Click [Create Menu] (O) and edit the DVD menu as
required, then click [Write to Disc] (O).
13 Check [Create disc] (_), select the drive to be
used (O) and then click [Write] (_).
14 Insert a brand-new 12 cm (5") DVD-RW or DVD-R disc into F_
the disc drive and click [OK].
• 12 cm (5") +RW and ÷R discs can also be used if the disc drive supports them.
15 Proceed with the write setting and then click [OK].
Writing to the disc starts.
• Depending on the amount of data, writing to the disc may take time.
• When the unit is connected to a computer, the
operation mode cannot be changed and its
power cannot be turned off.
in this case, disconnect the USB cable (4 below).
• When the unit is connected to a computer in disc
playback mode, no image will appear on the LCD
monitor or vtewfinder
• When this unit is connected to a computer, you
cannot use this unit's DISC EJECT lever to remove
a disc. Use the software's eject button to eject the
disc.
When the drive icon is displayed on the desktop:
• When a computer isaccessing a disc in this unit,
the ACCESS/PC tamp lights. Do not disconnect the
USB cable or AC adaptor while the disc is being
accessed as it may damage the data
E
O
Drag the icon into the Trash and then disconnect the USB cable.
When the drive icon is not displayed on the desktop:
Exit the application and then disconnect the USB cable.
• if you disconnect the USB cable white the access
lamp is on, it may damage the data.
139
LSQT1011
To Next Page
Loading...
