EasyManua.ls Logo

Panasonic DVD Palmcoder VDR-D250 - Page 33

Panasonic DVD Palmcoder VDR-D250
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Inserting/removing a disc
Identifying recording/playback sides of disc "SIDE A" mark
Single sided disc:
The recording/playback side is opposite to the labetled side.
Double sided disc:
The "SIDE A" recording/playback side is opposite to the "SIDE A" marked
side. The "SIDE B" recording/playback side is the "SIDE A" marked side.
The opposite side is
the "SI DE A" recording/
pIayback side.
Do not use excessive force when opening the cover.
Do not touch the pickup lens or the recording/
playback side of the disc.
This may impair recording and playback.
Insert the disc securely to prevent damage
When you open the cover, the ACCESS/PC lamp
flashes red Do not leave the cover open
If the cover is open, the power will not turn off even
if the OFF/ON switch is set to OFF
If the disc is not correctly inserted, the cover will not
close. Never try to forcibly c{ose the cover This
couId cause damage Reinsert the disc properIy
If a single sided disc is inserted into the unit with the
printed tabel facing the inside, an error message will
appear. Remove the disc and reinsert it with its
recording/playback side facing the inside
Do not allow the recording/playback side to become
dirty or scratched.
Do not remove the battery pack or disconnect the
AC adaptor while removing the disc or until power is
completely turned off. If you do, the cover will not
open If this happens, reattach the battery pack or
reconnect the AC adaptor, s{ide the DISC EJECT
Iever once, and then release it A repair disc
message may be displayed when the power is
turned back on. (-). 148, About recovery)
Do not insert anything other than the 8 cm (3")
DVD-RAM, DVD-RW or DVD-R disc into the disc
compartment. Doing so could cause malfunctions.
Do not touch the pickup tens or other parts inside
the disc compartment Be sure not to touch the area
around the pickup lens for it becomes extremely
hot
(fJ
WhiIe the ACCESS!PC lamp is lit, the disc is i'otating and disc inforrnati0n is being recorded: If
the power supply is interrupted at this time, the disc may become unusable. Do not disconnect
the AC adaptor or remove the battery. Also, do not strongly shake or cause impact to the unit.
33
LSQT1011

Table of Contents

Related product manuals