5-18
Code Item Function (Factory setting)
28 Total copy count 0: Does not count up 0
(Except FP-7818) 1: Count up
Checking double feed
by comparison between
in/out copies.
29 Not used
30 Skyshot mode 0: not change registration void position 1
(Using ADF) 1: change registration void position
31 ADF switch back 0: No 0
1: Yes
32 SADF function 0: No 0
1: Yes
33 F
2, ADF operation 0: not operated 0
(in case of no originals) 1: operated
34 Multi-feed default 0: off 1: on 0
35 Sorter initial mode 0: Non sort 2: Staple sort 0
setting 1: Sort 3: Group
36 Paper alignment function 0: Yes 0
(Except sort mode) 1: No
37 Countdown sorting function 0: No 1
1: Yes
38 Duplex unit initial 0: Does not select 0
mode setting 1: 1 sided to 2 sided
(Except FP-7818) 2: 2 sided to 2 sided
3: Book to 2 sided
39 Staple position default 0: Single front 0
(FP-7845/7850) 1: double
2: Single rear
40 Double count (Total 0: Single 1
counter, Key counter, 1: Ledger/A3
and Electronic counter) 2: Ledger/Legal/A3/B4
41 Count up timing 0: At paper feed roller clutch 1
(and sheet bypass solenoid)
1: At paper exit sensor
42 Key counter and 0: Not installed 0
Departmental counter 1: Key counter installed
2: Departmental counter
43 Key counter count up same as F5-41 0
timing
44 Counter count up 0: Does not count up 0
(Interleaving, cover mode) 1: Count up
45 Hole punch default 0: No 0
1: Yes
46 Hole punch indication change 0: 2 holes 1 (for American)
1: 3 holes 2 (for European)
2: 4 holes
To Next Page
Loading...
