5-20
Code Item Function (Factory setting)
70 Preventive maintenance 0: No call 10 (FP-7818/7824)
1: 1.5K 2: 2.5K 3: 5K 12 (FP-7830/7835/
4: 10K 5: 15K 6: 20K 7845/7850)
7: 30K 8: 40K 9:60K
10: 80K 11: 90K 12: 120K
13: 160K
71 Preventive maintenance 0: No indication 1
(Duplex unit) 1: Indication
72
Copier operation (After cleaning
0: Continuous copier operation 1
web roller counter is reached to
1: Copier stops or copy cycle is inhibited.
0)
73 Cleaning web roller counter 0: 120k 0 (FP-7830/7835/
selection 1: 80k 7845/7850)
1 (FP-7818/7824)
74–79 Not used
80 Paper size selection 0: LETTER R/A4R 1: LEGAL/B4 0
priority 2: LETTER/A4 3: LEDGER/A3
4: INVOICE/B5R 5: INVOICE/B5
81 B4/Foolscap size 0: B4 1: Foolscap 1 0
selection 2: Foolscap 2 3: LD
82 Sky shot mode 0: OFF 1: M1 ON 0
2: M2 ON 3: M1, M2 ON
83 Auto edge default 0: OFF 1
1: ON
84 Paper tray selection 0: LCC > System (lower to upper) > Copier 0
priority (lower to upper) > Sheet bypass
(Left to Right) 1: Copier (upper to lower) > System (upper
to lower) - LCC - Sheet bypass
2: LCC > Copier (upper to lower) > System
(upper to lower) > Sheet bypass
85 Auto selection 0: None 0
prohibition paper tray 1: Copier (upper) 2: Copier (lower)
setting (1) 3: System console (upper)
4: System console (middle)
5: System console (lower)
6: LCC
7: Sheet bypass
86 Auto selection prohibition same as F5-85 0
paper tray setting (2)
87-89 Not used
90 Beep sound 0: None 1
(FP-7845/7850) 1: Yes
91* Check size M1 Y Width of paper parallel position to paper 160
feed direction
92* Check size M1 X Length of paper vertical position to paper 70
feed direction
93* Check size M2 Y Width of paper parallel position to paper 220
feed direction
To Next Page
Loading...
