3. Drag a part to place it on the base screen.
In the following figure, two lamp switch parts have been placed on the screen.
4. On the [File] menu, press [Save As].
A dialog box for checking the save destination will be displayed.
5. Select the path of the save destination, enter the name of the folder to save
the data in, and then press [Save].
The folder will be created, and then multiple files will be saved in the folder.
If you close the screen after placing parts or drawing in the screen data, the
screen will be registered to the file manager and will be displayed
highlighted in red.
All the screen data is saved as a folder. The number of files varies
depending on the number of screens and the parts that are used. Do not
mistakenly delete any of the files. To open the screen data, select the "GTT
file."
To Next Page
Loading...
