Panasonic GT series - Transferring Data

2.5 GTWIN Ver. 3 Usage Procedures
2-19
2.5.4 Transferring Data
This section provides the procedure covering how to transfer screen data created in GTWIN
to the GT.
 Procedure
1. On the [Communication] menu, select [Communication Parameters].
The [Communications settings] dialog box is displayed.
2. Check that the network is set to [USB(GT)], and then press [OK].
3. On the [Communication] menu, select [Send All Data from GTWIN → GT].
The screen data and configuration data is transferred from GTWIN to the GT.
 In GTWIN Ver. 3, a [Send Difference from GTWIN → GT] function is available.
This function transfers only the difference of screen data and setting
information before and after change, which leads to great reductions in the
transfer time.
 You can also select the data to transfer by using the [Send/Receive
Selected Data] function.
 The USB driver must be installed for the first time that you connect to your
PC. Refer to the GTWIN Installation Guide (English Edition).