Panasonic GT series - Drawing and Setting Lamp Switch Parts (2) Switch Parts

Creating Screens
3-8
3.2.3 Drawing and Setting Lamp Switch Parts (2) Switch Parts
Draw the parts that function as switches.
 Drawing
1. Use the library switching list in the parts library to select [Switch].
2. Drag a lamp switch part from the parts library to the base screen.
3. Select SW0, the lamp switch part that you have placed on the screen.
4. Drag one of the ■ marks displayed in the corners of the part to change its
size.
 Completed area (switch parts are placed)
The sections surrounded by the yellow lines indicate the completed areas through this
procedure.