3.2 Creating the Main Panel (Base Screen: B-0)
Setting part attributes
1. Double-click the lamp switch part whose attributes you want to set.
A dialog box for setting its attributes is displayed.
2. Set the necessary attributes.
Replacement
Operation:
Lamp (ON/OFF)
Device: R100
Select From Design
Library,
LP_R_CB2_G
Replacement
Operation:
Lamp (ON/OFF)
Device: R101
Select From Design
Library,
LP_R_CB2_O
Replacement
Operation:
Lamp (ON/OFF)
Device: R102
Select From Design
Library,
LP_R_CB2_R
Replacement
Operation:
Lamp (ON/OFF)
Device: R103
Select From Design
Library,
LP_R_CB2_B
Settings that are not changed from the initial settings are listed as "-" or are
omitted.
You can also set the part attributes by selecting [Parts Attribute] in the
context menu displayed when you right-click the part.
To Next Page
Loading...
