Panasonic GT series - Creating the Language Switching Screen (Base Screen: B-2); Creating the Base Screen

3.4 Creating the Language Switching Screen (Base Screen: B-2)
3-21
3.4 Creating the Language Switching Screen (Base
Screen: B-2)
3.4.1 Creating the Base Screen
This section explains the procedure for placing switch parts on the base screen (B-2).
1. Select [B] under [Screen type] in the file manager, and then double-click the
button for screen number 2.
Base screen 2 is created.
2. Draw a character string.
3. Select a switch part from the parts library, and then place three parts in total.
In this example, select [FS_R_RB1_W] from the design library for each part.
 Completed area (switch parts are placed)
The section surrounded by the yellow line indicates the completed area through this procedure.