4.1 Useful Functions for Editing/Setting
Converting switch parts to lamp/message parts and vice-versa
The following section explains the procedure for converting a switch part that has been placed
from the [Switch] library into a lamp/message part.
1. Double-click a part that has been placed.
The [Lamp Switch Part] dialog box, which can be used to set part attributes, is
displayed.
2. Select [Lamp/Message].
A cautionary message informing you of the conversion from the switch part to the
lamp/message part is displayed.
3. Press [OK].
The part is converted to a lamp/message part, and the attribute settings in the
dialog box are also converted.
To Next Page
Loading...
