- 41 -
The used space and remaining recordable time of the SD card and built-in memory can be checked.
≥ //
Touching [CHANGE MEDIA] switches the unit between the display for the SD card and the
display for the built-in memory.
≥ The remaining recordable time in the currently set Recording Mode is displayed only in the
Motion Picture Recording Mode.
≥ Touch [EXIT] to close the indication.
≥ The SD card or built-in memory requires some space to store information and manage system
files, so the actual usable space is slightly less than the indicated value. The usable SD card/built-
in memory space is generally calculated as 1 GB=1,000,000,000 bytes. The capacities of this
unit, PCs and software are expressed as 1 GB=1,024k1,024k1,024=1,073,741,824 bytes.
Therefore, the indicated value of the capacity appears to be smaller.
The firmware version of this unit is displayed.
You can update the firmware version of this unit.
This item is used to start the unit demonstration.
≥ If [DEMO MODE] is switched to [ON] and you touch [EXIT] when there is no SD card inserted and
while this unit is connected to the AC adaptor, the demonstration automatically starts.
If any operation takes place, the demonstration is cancelled. However if no operations take place
for approx. 10 minutes, the demonstration automatically starts again. To stop the demonstration,
set [DEMO MODE] to [OFF] or insert an SD card.
≥ When Demo Mode is in operation, the lens cover remains open.
[MEDIA STATUS]
: [SETUP] # [MEDIA STATUS]
[Version Disp.]
: [SETUP] # [Version Disp.]
[Version Up]
: [SETUP] # [Version Up]
For the latest update information, check the support website below. (As of December
2014)
http://panasonic.jp/support/global/cs/e_cam
(This Site is English only)
[DEMO MODE]
: [SETUP] # [DEMO MODE] # [ON]
MENU
WX970M
MENU
MENU
MENU
To Next Page
Loading...
Need help?
General