117
= Restart Control Panel
Note:
This will cause a restart of the Control Panel
Application Software only.
Use the “Cancel” button to abort the dialog.
Use the button to confirm and close the entry.
The 2 Digipots located above the Numeric Keypad delegation buttons can be
used for mainly 2 things:
- the lower Digipot—in the upper as well as in the lower Deck—
can adjust
Transition Duration times, once delegated by according function. When
delegated by one of the Main “T-
DUR” buttons located right above the Fader
arms, the upper Digipot does not provide any functionality (yet!).
- the upper Digipot—in the upper as well as in the lower Deck—
by according “Next Transition” delegation 1–
8, can adjust Transition attributes
such as “Norm, Reverse, or Norm/Reverse” run directions for DVE or Wipe
transitions, if assigned for designated “Next Transition” delegation.
= Reboot Control Panel
Note:
This will cause a full reboot of the Control Panel,
including Operating System and Application Software,
similar to a power cycle.
Use the “Cancel” button to abort the dialog.
Use the button to confirm and close the entry.
To Next Page
Loading...
