CW_TONE1_GAIN
Value Format INTEGER
Description Specifies the gain, in decibels, of call waiting tone 1.
Value Range -24–24 (dB)
Default Value 0
HOLD_TONE_FRQ
Value Format Comma-separated Integer
Description Specifies the dual-tone frequencies, in hertz, of the hold tone using 2
whole numbers separated by a comma.
Value Range 0, 200–2000 (Hz) (0: No tone)
Default Value 425
HOLD_TONE_GAIN
Value Format INTEGER
Description Specifies the gain, in decibels, of the hold tone.
Value Range -24–24 (dB)
Default Value 0
BELL_CORE_PATTERN1_TIMING
Value Format Comma-separated Integer
Description Specifies the cadence, in milliseconds, of pattern ID 1, described in
the LSSGR, GR-506-CORE, "Signaling for Analog Interfaces" section
14, using up to 8 whole numbers (on 1, off 1, on 2, off 2…) separated
by commas.
Value Range 0–5000 (msec) (0: Continuous)
Note
• Avoid setting 1–50 for any of the values.
Default Value 2000,4000
BELL_CORE_PATTERN2_TIMING
Value Format Comma-separated Integer
Description Specifies the cadence, in milliseconds, of pattern ID 2, described in
the LSSGR, GR-506-CORE, "Signaling for Analog Interfaces" section
14, using up to 8 whole numbers (on 1, off 1, on 2, off 2…) separated
by commas.
Value Range 0–5000 (msec) (0: Continuous)
Note
• Avoid setting 1–50 for any of the values.
Default Value 800,400,800,4000
5.3.33 Tone Settings
326 Administrator Guide Document Version: 2017-07
To Next Page
Loading...
