Feature
Default
Type 1
(with )
Type 2
(without )
KX-TDE100/
KX-TDE200
KX-TDE600
Printing Message
761 761 761
Extension Dial Lock set/cancel
*1
77 77 77
Time Service Switch
*1
780 780 780
Remote Extension Dial Lock off
*1
782 782 782
Remote Extension Dial Lock on
*1
783 783 783
NDSS Monitor Release 784 784 784
Trunk Busy Out Clear
785 785 None
Extension Feature Clear
*1
790 790 790
Extension Personal Identification Number (PIN)
set/cancel
*1
799 799 799
Dial Information (CTI) None None None
Other PBX Extension Number (TIE) 1–16 None None None
Quick Dialling
*3
None None None
*1
SIP extension
users can use these feature numbers. If these feature numbers do not work properly with the KX-HGT100, ensure
that the firmware of the KX-HGT100 and the MPR software file version of the PBX are updated to their latest versions.
*2
These settings are unrelated to PBX feature numbers and are set directly via the telephone. If the number set to the telephone
is also used as a PBX feature number, the number functions as the telephone's feature number, and not as a PBX feature
number. See 4.4.1 Registering IP Telephones in the IP Networking Guide for programming details.
*3
It is possible to register Quick Dialling numbers that overlap with other registered numbers. This is used for the Automatic
Rerouting of VoIP Calls To Public Trunk feature.
2. Flexible Numbering (available while a busy, DND, or ringback tone is heard)
Feature numbers which are available while a busy, DND, or ringback tone is heard can be customised for
easy use. The numbers should be one digit ("0" through "9", "
", or "#") and must not conflict. For default,
refer to the following table:
[Flexible Numbering Table (available while a busy, DND, or ringback tone is heard)]
Feature Default
Call Waiting/DND Override
*1
1 or 2
*2
Executive Busy Override 3
Message Waiting set
*1
4
Call Monitor 5
Automatic Callback Busy/CCBS 6
Alternate Calling
—Ring/Voice
*1
SIP extensions cannot perform DND Override or Message Waiting but can be the recipient of them.
*2
To use Call Waiting/DND Override, both "1" and "2" are available by default.
Feature Guide 429
2.3.6 Flexible Numbering/Fixed Numbering
To Next Page
Loading...
