2.1 PT Programming
2.1.1 Programming Instructions
Required Telephone/Extension
PBX
settings can be customized through system programming by using a multi-line display Digital Proprietary
Telephone (DPT) or IP Proprietary Telephone (IP-PT), such as the KX-NT343, KX-NT346 or KX-NT500 series.
Multi-line display Analog Proprietary Telephones (APTs) are not supported. To access system programming,
the Class of Service (COS) assigned to the PT’s extension must be programmed to allow system programming,
or the PT must be connected to the lowest-numbered port on the card installed in the lowest-numbered slot.
Only one system programming session can be performed at a time. This means that only one user can access
system programming at a time, whether through a PT or PC.
For a list of characters that can be entered during system programming, see Section 1.1.3 Entering
Characters.
Buttons and Functions
Fixed Buttons
Function
KX-DT300/KX-DT500
KX-NT300/KX-NT500
KX-T7600
PREVIOUS
NEXT
(Page up)
(Page down)
ENTER
Back to Previous Menu
(CANCEL)
SHIFT
PROGRAM
END
SELECT
14 PT Programming Manual Document Version 2014-11
2.1.1 Programming Instructions
To Next Page
Loading...
Need help?
General