2.4.2 LAN Connections for IP Telephones
When an IP telephone is connected to the LAN and power is supplied for the first time, you will be prompted
to set network parameters. The network parameters must be set for the IP telephone before it can be used.
Refer to "4.3 Assigning Networking Information to IP Telephones
" for instructions.
Connecting an IP Telephone to a Switching Hub
When connecting an IP telephone to the LAN, connect it to a switching hub.
Note
Since
an IP softphone is installed and operates on a PC, the PC must be connected to the LAN to use the
IP softphone on the network.
The diagram below is for connecting an IP-PT to a switching hub. For SIP phones, refer to the documentation
of your SIP phone.
Example: KX-NT346
Ethernet Straight Cable
To a Switching Hub
16 Getting Started
2.4.2 LAN Connections for IP Telephones
To Next Page
Loading...
