1. After Easy Setup Wizard launches, the Easy Setup
Wizard screen appears:
a. In WebMC Language Setting, select a language
from the drop-down list.
b. In PBX Type, select a PBX type.
Standalone:
This
PBX will be used as a standalone system. The
standalone PBX controls all terminals, trunks, and
applications.
Slave:
This PBX will serve as a Slave unit in a One-look
network. The Slave unit can share setup information
and resources controlled by the Master unit.
Note
When Slave is selected, the Location Setting
and Password Setting are not editable. Skip
these settings and go to One-look Network
(step e).
c. In Location Setting, select a location from
drop-down list.
d. In Password Setting, enter a password for the
Installer level account. In Re-enter, enter the same
password.
e. When Slave is selected in step b, in One-look
Network, specify whether to activate the 60-day
One-look Networking Trial Activation Key.
– If Active is selected, the 60-day trial will begin
when the Easy Setup Wizard is completed.
– If Non Active is selected, you will have to
activate the trial manually in order to use
One-look Networking Features on a trial basis.
f. Click Start Setup Wizard.
Note
If the location is changed from its default value, a
notice about restarting the PBX is displayed. Click
OK to restart the PBX. After the PBX restarts, start
Web Maintenance Console again
(refer to
"Connecting to Web Maintenance Console" in
"3.3 Starting Web Maintenance Console"). When
you start the Easy Setup Wizard again, you will start
from step 1, below.
Getting Started 29
4.1.1 Easy Setup Wizard
To Next Page
Loading...
