Panasonic KX-NS500 - Page 32

7. In the VoIP (Ext) settings:
In Number of IP Extensions:
a. In IP-PT(NT), specify the number of IP-PT
extensions.
b. In UT/UDT, specify the number of UT/UDT
extensions.
c. In SIP-Phone, specify the number of SIP
extensions.
Note
You can confirm the required number of virtual
IP
extension cards, total IP extensions and total
virtual IP extension cards.
d. In IP Terminal Registration Mode, select one of the
following options:
• Manual: Manually register IP terminal
information.
• Full Automatic: Automatically register IP
terminal information.
• Extension Number Input: Automatically
register IP terminal information except the
extension number. The extension number can
then be registered from the IP telephone
manually.
Note
• The Full Automatic
and Extension Number
Input registration modes may not be
available for certain types of IP terminals. In
such cases, select Manual as the
registration mode.
• For more information about the IP terminal
registration modes, refer to
"4.3.2 Registering IP Telephones".
e. In DHCP Server, select either Disable or Enable.
f. If you select Enable in DHCP Server, enter valid
settings for the automatic assignment of IP
addresses.
g. Click Finish.
8. Follow the prompts of the Easy Setup Wizard. If LAN
settings were changed from their default values in step
6,
you will be prompted to restart the PBX after the Easy
Setup Wizard is complete. Click OK to restart the PBX.
The login screen will be displayed. Click Skip to finish
the Easy Setup Wizard and continue the configuration
from the home screen without restarting the PBX.
Notice
If you select Skip, restart the PBX after completing
the settings.
32 Getting Started
4.1.1 Easy Setup Wizard