For IP-CSs
• Using a DHCP server (DHCP Server feature or an external DHCP server) when the IP
-CS is on the
same LAN as the PBX
The DHCP server automatically assigns the IP address of the IP-CS, the subnet mask address, and the
default gateway address to the IP-CS.
The PBX’s IP address can also be assigned automatically to the IP-CS in the process of being registered
to the PBX. For details about registering the IP-CS, refer to "4.3.2 Registering IP Telephones" and
corresponding manuals for the IP-CS.
Note
• For
information about the DHCP Server feature, refer to "8.1.2 DHCP (Dynamic Host Configuration
Protocol) Server" in the Installation Manual.
• Using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-CS is on a
remote office LAN
While the DHCP server automatically assigns the IP address of the IP-CS, the subnet mask address, and
the default gateway address to the IP-CS, the PBX’s IP address must be assigned manually.
To assign the PBX’s IP address, refer to corresponding manuals for the IP-CS.
If you need to set VLAN parameters, refer to the corresponding manuals for the IP-CS.
Note
• By assigning the PBX’s IP address to one IP-CS (KX-NS0154
only), it is possible to assign the
PBX’s IP address to other IP-PTs or IP-CSs on the same LAN through system programming. For
details, refer to "9.18 PBX Configuration—[1-1] Configuration—Slot—Port
Property—V-IPCS—Option—
Announce Mode" in the PC Programming Manual.
• IP-CSs
can only receive IP addressing information from a DHCP server on its own LAN. Therefore,
when IP-CSs are located on several LANs, a DHCP server is required on each LAN.
• Since the default setting of the DHCP client function is enabled for IP-CSs, simply connect the
IP-CSs to the LAN to use the DHCP server.
• Not using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-CS is on
the same LAN as the PBX
Only the PBX’s IP address can be assigned automatically to the IP-CS in the process of being registered
to the PBX. For details about registering the IP-CS, refer to "4.3.2 Registering IP Telephones" and
corresponding manuals for the IP-CS.
To assign the IP address of the IP-CS, the subnet mask address, and the default gateway address
manually, refer to corresponding manuals for the IP-CS.
If you need to set VLAN parameters, refer to corresponding manuals for the IP-CS.
• Not using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-CS is on
a remote office LAN
All of the IP addressing information must be assigned manually.
To assign the IP addressing information, refer to corresponding manuals for the IP-CS.
If you need to set VLAN parameters, refer to corresponding manuals for the IP-CS.
Note
By assigning the PBX
’s IP address to one IP-CS (KX-NS0154 only), it is possible to assign the PBX’s
IP address to other IP-PTs or IP-CSs on the same LAN through system programming. For details, refer
to "9.18 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-IPCS—Option—
Announce Mode" in the PC Programming Manual.
52 Getting Started
4.3.1 Assigning IP Addressing Information
To Next Page
Loading...
