Telephone Features 3-105
3.2 Telephone Features P
Conditions
• An account code must be stored by pressing “ ” and entering the account code after
the line access code in the account code verify-all and forced modes.
• You can store an extension number, telephone number, or feature number of up to
twenty-four digits. Valid digits are “0 through 9”.
• A pause can be stored by pressing the key. However, in the account code verify-all,
verify-toll and forced modes, “ ” is not regarded as a pause.
• To store the telephone number of an external party, a line access code (9 or 81 through
86) must be stored as the first digit.
• The number of Personal Speed Dialing numbers corresponds to the number of PF
buttons assigned as One-Touch Dialing. (PF buttons are on a proprietary telephone.)
You cannot assign both the One-Touch Dialing and Personal Speed Dialing features to
the same number. For example, if you assign One-Touch Dialing to the PF 1 button and
then Personal Speed Dialing 0, only the Personal Speed Dialing 0 feature will be
assigned.
• A rotary telephone cannot use this feature.
Programming Reference
• Station Programming (Section 2)
Flexible Button Assignment — One-Touch Dialing Button
SLT
PT
To Next Page
Loading...
