Panasonic KX-TA624 - Page 227

Appendix 5-7
5 Appendix
Conditions
• If the displayed characters exceed sixteen digits, “&” is shown on the right-hand side of
the display.
• The duration time display is only shown when you make or receive an outside call.
The Count start time for outgoing calls can be programmed as desired.
• When you confirm key programming, be sure to press the button while on-hook.
Display Description
Message Waiting
MW-123
Night
Not Stored
Other CO Key
Playback 1:00
Pref. In :CO-2
Pref. In :No
Pref. In :Ring
Pref. Out:CO-2
Pref. Out:Idle
Pref. Out:No
Private
Record 1 :00
RNG:1,2,3,4,5,6
Save Button
Tone Call
TRK GRP-6
Voice Call
VTR-101
2WAY-REC:101
2WAY-TRANS:101
092-555-2111
EXT-101
Restored the Message Waiting (MESSAGE) button.
The Another Extension Message Waiting button is assigned.
The Night button is assigned.
No programming is assigned.
The Other-CO (O-CO) button is assigned.
When playing back the OGM.
Selecting a “Prime Line Preference — Incoming”.
Selecting a “No Line Preference — Incoming”.
Selecting a “Ring Line Preference — Incoming”.
Selecting a “Prime Line Preference — Outgoing”.
Selecting an “Idle Line Preference — Outgoing”.
Selecting a “No Line Preference — Outgoing”.
Selecting a Private mode.
— “Live Call Screening (LCS)”.
When recording the OGM.
Selecting an “Outside (CO) Line Ringing Selection”.
The SAVE button is assigned.
Selecting a Ring-Calling mode.
The Group-CO (G-CO) button is assigned.
Selecting a Voice-Calling mode.
The Voice Mail (VM) Transfer button is assigned.
The Two-Way Recording button is assigned.
The Two-Way Transfer button is assigned.
The One-Touch Dialing button is assigned.
The Station Lock button is assigned.