Panasonic KX-TDA100 - Page 329

1.19 V
Feature Manual 329
b) Intercept Routing to a Mailbox of the VPS
The PBX sends a mailbox number of the corresponding extension to the VPS when a CO line call
is intercepted from an extension to the VPS. Therefore the caller can leave a message for the
called extension without knowing the mailbox number.
[Intercept Routing to the VPS Sequence Selection]
If an extension user sets Intercept Routing to the VPS, the intercepted CO line calls will be
redirected to the VPS.
It is also possible to send the AA command, even in the VM service mode, when calls are
intercepted so that the caller can be directed to an extension rather than a mailbox. This can be
performed by selecting "AA" through system programming.
→ 2.9.18 [3-8-1] VM(DTMF) Group—System Settings—Others—Intercept Routing to the VPS
Sequence
[Example of a) & b)]
Parameter
Transmitted Command
In AA Service Mode In VM Service Mode
Answer by Mailbox
(Default)
Switching to VM command +
Recording message command (#6
+ H [H = Mailbox No.])
Recording message command (H
[H = Mailbox No.])
AA Switching to AA command (#8) Switching to AA command (#8)
None (DTMF commands are not sent. Work with default of the VPS.)
Parameter
Transmitted Command
In AA Service Mode In VM Service Mode
Answer by Mailbox Switching to VM command +
Recording message command (#6
+ H [H = Mailbox No.])
Recording message command (H
[H = Mailbox No.])
AA Switching to AA command (#8) Switching to AA command (#8)
None (Default) (DTMF commands are not sent. Work with default of the VPS.)
CO Line Call
Operator
Extn. 102
VM Port 1 VM Port 2
VM Port X
VM Port 3
VM (DTMF)
Group
VPS (In AA service mode)
FWD, Intercept
PBX
Transfer
Sent "#6" + "102".
Switching to VM command
mailbox number