Panasonic KX-TDA100 - Page 332

1.19 V
332 Feature Manual
2.9.18 [3-8-1] VM(DTMF) Group—System Settings
→ VM DTMF Status Signal—Ringback Tone
→ VM DTMF Status Signal—Busy Tone
→ VM DTMF Status Signal—Reorder Tone
→ VM DTMF Status Signal—DND tone
→ VM DTMF Status Signal—Answer
→ VM DTMF Status Signal—Confirm
→ VM DTMF Status Signal—Disconnect
→ VM DTMF Status Signal—FWD to VM Ringback Tone
→ VM DTMF Status Signal—FWD to VM Busy Tone
→ VM DTMF Status Signal—FWD to Extension Ringback Tone
Conditions
• Voice Mail (VM) Transfer Button
A flexible button can be customized as the Voice Mail (VM) Transfer button with the floating extension
number of the VM group as the parameter.
• It is possible to assign the time period between when the VPS answers the call and the PBX sends the
Follow on ID to the VPS.
→ 2.9.18 [3-8-1] VM(DTMF) Group—System Settings—Timing—Waiting Time before Sending Follow
on ID
• It is possible to assign the time period between when the VPS transfers the call using the AA service
to the PBX and the PBX sends the DTMF status signal to the VPS.
→ 2.9.18 [3-8-1] VM(DTMF) Group—System Settings—Timing—DTMF Length for VM
FWD EXT RBT (FWD to
extension ringback tone)
The PBX is calling an extension other than the one
dialed. FWD or Idle Extension Hunting (→ 1.9.9 Idle
Extension Hunting) may be assigned by the called
extension.
8
Confirm (confirmation
tone)
The PBX receives confirmation that the feature has
been successfully set or canceled (e.g., Message
Waiting) on the extension.
9
Disconnect The caller has hung up. #9
[Example] An incoming call reaches the VPS. The VPS greets
the caller: "Thank you for calling Panasonic. If you
know the extension number of the person you wish…
".
The caller dials the extension number (extn. 102).
The VPS will transfer the call to the extension via the
PBX.
If the extension is not available, the PBX sends
DTMF status signal of the extension (busy status) to
the VPS.
The VPS receives the DTMF status signal and send
the appropriate message to the caller: "Sorry. The
extension is busy. Would you like to leave a
message… ".
Status Condition
Default
Command
VPS
Extn.
102
1
3
4
Sent "2".
Busy
Status
Busy
PBX
Transfer
2
1
2
3
4