EasyManua.ls Logo

Panasonic KX-TDE100 - Intercept Routing-No Destination

Panasonic KX-TDE100
392 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
This feature may not be available depending on the specifications of some CO lines. Also, this feature is
not available when the original call was made from a SIP extension.
PC Programming Manual References
4.5 [2-3] Timers & Counters
→Dial / IRNA / Recall / Tone— Intercept Routing No Answer (IRNA)—Day, Lunch, Break, Night
→DISA / Door / Reminder / U. Conf— DISA—Intercept Timer—Day, Lunch, Break, Night
5.12 [3-5-1] Incoming Call Distribution Group—Group Settings
→Overflow
No Answer—
Time out & Manual Queue Redirection—Destination-Day, Lunch, Break, Night
6.1 [4-1-1] Wired Extension—Extension Settings
→Intercept Destination
→Intercept No Answer Time
6.10 [4-2-1] Portable Station—Extension Settings
→Intercept Destination
→Intercept No Answer Time
7.3
[5-3-1] Voice Message—DISA System—Option 1—
DISA Intercept—Intercept when all
DISA ports are
busy
12.6 [10-4] Miscellaneous
→
Intercept—Intercept Routing - DND (Destination sets DND.)
→ Intercept—Routing to Operator - No Destination (Destination is not programmed.)
→ Intercept—Intercept Routing for Extension Call
PT Programming Manual References
[203] Intercept Time
[604] Extension Intercept Destination
[625] Destination for Overflow Time Expiration
Feature Manual References
4.1.8 DISA (Direct Inward System Access)
4.1.10 DND (Do Not Disturb)
9.1.12 Intercept Routing—No Destination
Description
Directs a CO line call to an operator when the call has no assigned destination.
Conditions
• Intercept Routing—No Destination on/off
Intercept Routing—No Destination can be enabled or disabled for the entire system, through system
programming. If disabled, the caller will hear a reorder tone.
Note that calls
received through an ELCOT/LCOT or T1 (LCOT/GCOT) card will always be directed to an
operator, even when this feature is disabled.
• If an operator is not assigned:
The default intercept destination will be the extension connected to the lowest numbered port, on the card
installed in the lowest numbered slot.
• Intercept Routing—No Destination also applies to calls from doorphones.
164 Feature Manual Document Version 2009-12
9.1.12 Intercept Routing—No Destination

Table of Contents

Other manuals for Panasonic KX-TDE100

Related product manuals