3.2 Connection
66 Installation Manual
3.2 Connection
3.2.1 Connection
PBX features and settings can be customised using a PC and the KX-TE308 Maintenance Console
software.
Programming can be performed both on-site, using a PC connected directly to the PBX, and off-site,
by accessing the PBX via modem.
Serial Interface Connection
A PC can be connected to the RS-232C port of the PBX, or to the USB port for faster access.
Notes
• For pin assignments and maximum cabling distance, refer to "2.8 Connecting Peripherals".
• When connecting the KX-TE308 Maintenance Console to the PBX using an RS-232C cable,
assign the following values to the Serial Interface (RS-232C) port of the PBX through system
programming, "SMDR RS-232C Parameter [800]":
• Baud Rate: 9600 bps
• Word Length: 8 bits
• Parity Bit: None
• Stop Bit: 1 bit
Installing the USB Driver
CAUTION
Installing the USB driver may prevent the USB driver for KX-TDA series or PC Console/Phone
Software from functioning correctly. In this case, update the USB drivers as necessary from the
following folders on the included CD-ROM:
RS-232C Port
USB Port
PC
PC
To USB Port
To COM Port
To Next Page
Loading...
