3.2 Connection
70 Installation Manual
3.2.3 Accessing PBX via Internal Modem
When the mode of the PBX outside (CO) line that will be accessed is 'MODEM':
1. For Dial Number, enter the telephone number assigned to the internal modem of the PBX.
2. Select Auto (Tone) or Auto (Pulse) for Dial Type.
3. Click OK.
4. Click OK. The PC will connect to the PBX.
When the mode of the PBX outside (CO) line that will be accessed is 'DISA':
1. For Dial Number, enter the telephone number assigned to the internal modem of the PBX,
several pause symbols (',') and the Remote Maintenance Feature Number (for example:
01234567,,,,,729).
2. Select Auto (Tone) for Dial Type.
3. Click OK.
4. Click OK. The PC will connect to the PBX.
Notes
• The number of pause symbols to be inserted differs depending on the PC modem used.
• Auto (Pulse) Dial Type cannot be used.
When the mode of the PBX outside (CO) line that will be accessed is 'Normal':
1. For Dial Number, enter the pause symbol (',').
2. Select Manual for Dial Type.
3. Click Initialise.
4. Click OK.
5. Click OK.
6. Dial the telephone number assigned to the outside (CO) line from a telephone connected in
parallel with the PC.
1. Start the KX-TE308 Maintenance Console software
from the start menu on your PC. (Start o Programs
o KX-TE308 Maintenance Console)
2. Type the Installer Level Programmer Code that was
set during the KX-TE308 Maintenance Console
installation.
3. Click the check box to connect to the PBX. Options
will appear as shown here, on the left.
4. Type the System Password. (default: 1234)
5. Select Modem, and click Setup.
To Next Page
Loading...
