8.1.2. Handset
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.
H/S key operation H/S LCD
1). Press .
2). Select "Initial setting" using or
then press or
{>}.
{^} {V}
3). Enter "7", "2", "6", "2", "7", "6", "6", "4".
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
5). Enter "
ە
", "
ە
", "
ە
", "
ە
" (Address). (*1)
7). Press , a long confirmation beep
will be heard.
8).
Press to return to standby mode.
After that, remove and reinsert the batteries. Press the Power button for
about 1 second if the power is not turned on.
6). Enter "
㸨
", "
㸨
" (New Data). (*1)
4). Select "Write EEP" using or
then press or
{>}.
{^} {V}
MM
{OFF}
Naviga
(Volume) key
tor key/
?
{CLEAR}
Dial keypad
{MENU} {OK}
{MUTE} {PAUSE}
{OFF}
{FLASH} {CALL WAIT}
M
M
M
Default Data
Caller list
V^
_ _ _ _ _ _
Initial setting
V^
Ringer Setting
V^
Service mode
Read EEP
Write EEP
^
Set Addr.:
New Data
Set Addr.:
Set Addr.:
To Next Page
Loading...
