157
6. Stabiliser, Zoom and Flash
Setting the Flash Functions
• [Flash] in the [Rec] menu is available only when an external flash is attached.
Applicable modes:
Select whether to set the flash output automatically or manually.
• The firing mode cannot be set with the camera when using a flash (DMW-FL580L/
DMW-FL360L/DMW-FL200L: optional). It can be set with the camera only with certain flash
models capable of allowing you to change the firing mode by operating the camera.
1 Select the menu.
2 (When [MANUAL] is selected)
Select the menu.
3 Press 2/1 to set the luminosity ratio and then press [MENU/SET].
Changing the firing mode
> [Rec] > [Flash] > [Firing Mode]
[TTL] The camera automatically sets the flash output.
[MANUAL]
Set the luminosity ratio of the flash manually. In [TTL] you can shoot the
photograph you want even when shooting dark scenes that may
otherwise be too brightly lit by the flash.
• When [MANUAL] is set, the luminosity ratio ([1/1], etc.) is displayed on
the flash icon on the screen.
> [Rec] > [Flash] > [Manual Flash Adjust.]
To Next Page
Loading...
