261
10. Using the Wi-Fi/Bluetooth function
∫ Turning off the camera with the smartphone
1 Connect to a smartphone. (P253)
2 Operate the smartphone.
Not available in these cases:
• In the following case, remote recording does not work:
– When using [Time Lapse Shot]
1 Select [ ].
2 Select [ OFF].
• When [Remote Wakeup] is set to [ON], the Bluetooth function continues to operate even after
the camera is turned off, thus causing the battery to drain.
Taking images via a smartphone (remote recording)
Wireless connectivity required:
• If the smartphone is already connected via Wi-Fi, proceed
to step 3.
1 (When connected via Bluetooth) Select [ ].
2 (When connected via Bluetooth) Select [Remote
operation].
• Make a Wi-Fi connection automatically.
– (iOS devices) Depending on the connection status of the smartphone, you may need
to change the connected device on the Wi-Fi setup screen. Follow the on-screen
message on the smartphone to change the setting.
3 Select [ ].
4 Record an image.
• The recorded images are saved in the camera.
• Some settings are not available.
To Next Page
Loading...
