104 VQT2X62 VQT2X62 105
Meanings and required responses to major messages displayed on LCD monitor.
Message displays
[THIS MEMORY CARD CANNOT BE USED]
●
A MultiMediaCard was inserted.
→ Not compatible with the camera. Use a compatible card.
[THIS MEMORY CARD IS WRITE-PROTECTED]
●
Unlock the write-protect switch on the card. (→28)
[NO VALID PICTURE TO PLAY]
●
Take pictures, or insert a different card already containing pictures.
[THIS PICTURE IS PROTECTED]
●
Release the protection before deleting, etc. (→93)
[SOME PICTURES CANNOT BE DELETED] [THIS PICTURE CANNOT BE DELETED]
●
Non-DCF pictures (→50) cannot be deleted.
→ Save needed data on a computer or other device, and then use [FORMAT] on the camera to
erase the card. (→40)
[NO ADDITIONAL SELECTIONS CAN BE MADE]
●
The number of pictures that can be deleted at once has been exceeded.
●
More than 999 pictures have been set as [FAVORITE].
●
The number of pictures allowing [TEXT STAMP] or [RESIZE] (multiple settings) at once has been
exceeded.
[CANNOT BE SET ON THIS PICTURE]
●
Pictures that do not conform to DCF standards cannot be used for [PRINT SET] and [TEXT
STAMP].
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN] [SYSTEM ERROR]
●
The lens is not working correctly.
→ Turn on power again.
(Consult the dealer or your nearest Service Centre if display still remains)
[SOME PICTURES CANNOT BE COPIED] [COPY COULD NOT BE COMPLETED]
●
Pictures cannot be copied in the following cases:
→ Picture of same name already exists in built-in memory when copying from card.
→ File is not of DCF standard.
→ Picture taken or edited on a different device.
[NOT ENOUGH SPACE ON BUILT-IN MEMORY] [NOT ENOUGH MEMORY ON THE CARD]
●
There is no space left on the built-in memory or the card. When you copy pictures from the built-in
memory to the card (batch copy), the pictures are copied until the capacity of the card becomes full.
[BUILT-IN MEMORY ERROR] [FORMAT BUILT-IN MEMORY?]
●
Displayed when formatting built-in memory via computer, etc.
→ Reformat directly using camera. Data will be deleted.
[MEMORY CARD ERROR] [FORMAT THIS CARD?]
●
The card format cannot be used with this camera.
→ Save needed data on a computer or other device, and then use [FORMAT] on the camera. (→40)
[INSERT SD CARD AGAIN] [TRY ANOTHER CARD]
●
Access to card has failed.
→ Insert card again.
●
Try with a different card.
[MEMORY CARD ERROR] [MEMORY CARD PARAMETER ERROR]
●
Card is not of SD standard.
●
When cards in capacities of 4 GB or more are used, only SDHC or SDXC Memory Cards are
supported.
[READ ERROR]/[WRITE ERROR] [PLEASE CHECK THE CARD]
●
Data read has failed.
→ Check whether card has been inserted correctly (→26).
●
Data write has failed.
→ Turn off power and remove card, before re-inserting and turning on power again.
●
Card may possibly be damaged.
●
Try with a different card.
To Next Page
Loading...
