Preparation
- 10 -
Charging the Battery
with the Charger
The battery is not charged when the camera
is shipped. Charge the battery before use.
1 Attach the battery with attention to
the direction of the battery.
2 Connect the charger to the
electrical outlet.
plug-in type
inlet type
• The AC cable does not fit entirely into the
AC input terminal. A gap will remain as
shown below.
• Charging starts when the [CHARGE]
indicator A lights green.
• Charging is complete when the
[CHARGE] indicator A turns off (after
about 120 minutes).
• When the [CHARGE] indicator flashes,
read P11.
3 Detach the battery after charging is
completed.
• After charging is completed, be sure to
disconnect the power supply device from the
electrical outlet.
• The battery becomes warm after using it and
during and after charging. The camera also
becomes warm during use. This is not a
malfunction.
• The battery will be exhausted if left for a long
period of time after being charged.
Recharge the battery when it is exhausted.
• The battery can be charged even if it is not
fully discharged.
• Use the dedicated charger and battery.
• Charge the battery with the charger
indoors.
• Do not disassemble or modify the
charger.
• Do not leave any metal items (such as
clips) near the contact areas of the power
plug. Otherwise, a fire and/or electric
shocks may be caused by
short-circuiting or the resulting heat
generated.
To Next Page
Loading...
Need help?
General
