- 125 -
Connecting to other equipment
Connecting to other equipment
Connecting to a PC
You can acquire recorded pictures to a PC by
connecting the camera and the PC.
The software [LUMIX Simple Viewer] or
[PHOTOfunSTUDIO-viewer-] (for Windows
®
)
in the CD-ROM (supplied) allows you to easily
acquire pictures recorded with the camera to
a PC, print them and send them by e-mail.
If you use “Windows
98/98SE”, install the
USB driver and then connect it to the
computer.
Read the separate operating instructions for
the supplied software for more information
about the software in the CD-ROM (supplied)
and how to install it.
A USB connection cable (supplied)
B AC adaptor (optional)
• Use a battery with sufficient battery power or
the AC adaptor (optional).
• Turn the camera off before inserting or
removing the cable for the AC adaptor
(optional).
• Set the camera to a mode other than [ ]
mode.
1 Turn on the camera and the PC.
2 Connect the camera to a PC via the
USB connection cable A
(supplied).
• Connect the USB connection cable with
the [ ] mark facing the [2] mark on the
[DIGITAL] socket.
• Hold the USB connection cable at 1 and
insert straight in or take straight out. (If
you forcibly insert the USB connection
cable at a slant or upside down you can
deform the connection terminals and
damage the camera or the connected
equipment.)
C This message appears during data
transfer.
DIGITAL
AV OUT
DC IN
1
ACCESS
To Next Page
Loading...
Need help?
General
