- 27 -
Preparation
LCD Monitor Display/
Switching the LCD
Monitor Display
∫ Screen display in normal picture mode
[ ] (at the time of purchase)
1 Recording mode
2 Flash mode (P47)
• If you press the shutter button halfway
when the flash is activated, the flash icon
turns red.
3 AF area (P29)
• The AF area displayed is bigger than
usual when taking pictures in dark
places.
4 Focus (P29)
5 Picture size (P81)
6 Quality (P81)
: Jitter alert (P31)
7 Battery indication
• The indication turns red and blinks if the
remaining battery power is exhausted.
(The status indicator blinks when the
LCD monitor turns off.)
Recharge the battery or replace it with a
fully charged battery.
• It does not appear when you use the
camera with the AC adaptor (optional)
connected.
8 Number of recordable pictures (P149)
9 Recording state
10 Built-in memory/Card
• The access indication lights red when
pictures are being recorded on the
built-in memory (or the card).
– When using the built-in memory
– When using the card
• Do not do the following when the access
indication lamps lights. The card or the
data on the card may be damaged and
this unit may no longer operate normally.
– Turn this unit off.
– Remove the battery or the card. (when
using a card)
– Shake or bump this unit.
– Disconnect the AC adaptor. (optional)
(when using the AC adaptor)
• Do not do the above when pictures are
being read or deleted or the built-in
memory (or the card) is being formatted.
(P124)
• The access time for the built-in memory
may be longer than the access time for a
card.
11 Shutter speed (P29)
12 Aperture value (P29)
• If the exposure is not adequate, the
aperture value and the shutter speed
turn red. (They do not turn red when the
flash is activated.)
13 Optical Image Stabilizer (P85)
1/30F2.8
13
12
4
56 7
1112
9
3
10
8
To Next Page
Loading...
