- 17 -
Preparation
Inserting and Removing
the Card (optional)/the
Battery
• Check that this unit is turned off.
• Close the flash.
• Prepare a card. (optional)
• You can record or play back pictures on
the built-in memory when you are not
using a card.
1 Slide the card/battery door to open
it.
• Always use genuine Panasonic
batteries.
• If you use other batteries, we cannot
guarantee the quality of this product.
2 Battery:
Insert it fully being careful about
the direction you insert it.
Pull the lever A in the direction of
the arrow to remove the battery.
Card:
Push it fully until it clicks being
careful about the direction you
insert it.
To remove the card, push the card
until it clicks, then pull the card out
upright.
• Do not touch the connection terminals of
the card.
• The card may be damaged if it is not fully
inserted.
3 1:
Close the card/battery door.
2:
Slide the card/battery door to the
end and then close it firmly.
• If the card/battery door cannot be
completely closed, remove the card,
check its direction and then insert it again.
• Remove the battery after use.
• Do not remove the battery with the
camera turned on since the settings on
the camera may not be stored properly.
• The supplied battery is designed only for
the camera. Do not use it with any other
equipment.
• Do not insert or remove the battery or the
card while this unit is turned on. The data
on the built-in memory or the card may
be damaged. Be particularly careful while
the built-in memory or the card is being
accessed. (P29)
• We recommend using a Panasonic card.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
