- 29 -
Preparation
LCD Monitor/Viewfinder
Display/Switching the
LCD Monitor/Viewfinder
Display
∫ Screen display in programme AE mode
[ ] (at the time of purchase)
1 Recording mode
2 Flash mode (P50)
3 AF area (P31)
• The AF area displayed is bigger than
usual when taking pictures in dark
places.
4 Focus (P31)
5 Picture size (P98)
6 Quality (P98)
: Jitter alert (P33)
7 Battery indication
• The indication turns red and blinks if the
remaining battery power is exhausted.
Recharge the battery or replace it with a
fully charged battery.
• It does not appear when you use the
camera with the AC adaptor (optional)
connected.
8 Number of recordable pictures (P167)
9 Recording state
10 Built-in memory/Card
• The access indication lights red when
pictures are being recorded on the
built-in memory (or the card).
– When using the built-in memory
– When using the card
• Do not do the following when the access
indication lamps lights. The card or the
data on the card may be damaged and
this unit may no longer operate normally.
– Turn this unit off.
– Remove the battery or the card (when
using a card).
– Shake or bump this unit.
– Disconnect the AC adaptor (optional).
(when using the AC adaptor)
• Do not do the above when pictures are
being read or deleted or the built-in
memory (or the card) is being formatted
(P140).
• The access time for the built-in memory
may be longer than the access time for a
card.
11 AF area selection (P103)
12 Joystick operation (P34, 42, 64, 65)
13 Shutter speed (P31)
14 Aperture value (P31)
• If the exposure is not adequate, the
aperture value and the shutter speed
turn red. (They do not turn red when the
flash is activated.)
15 Exposure compensation (P57)
16 Metering mode (P100)
17 Optical Image Stabilizer (P104)
17
12
4567
14 13
9
3
10
16
8
1/30
F2.8
1112
15
6
To Next Page
Loading...
