Panasonic Lumix DMC-LS80

40
VQT1L50
Advanced-Shooting
Available fl ash settings by recording mode
The available fl ash settings depend on the
recording mode.
(○ : Available, — : Not available, ◎ : Initial
setting)
*
2
*
2
*
2
It becomes Forced Flash ON [t],
when the backlight compensation
function is activated.
The fl ash setting may change when you
change the recording mode. Change the
fl ash setting again if necessary.
Flash settings are retained even if you
switch the camera off. However, scene
mode fl ash settings return to the factory
settings when you change the scene mode.
■
•
•
The available fl ash range to take
pictures
ISO sensitivity Available fl ash range
AUTO 30 cm (0.98 feet) to 5.9 m
(19.36 feet) (Wide)
30 cm (0.98 feet) to 3.2 m
(10.50 feet) (Tele)
ISO100 30 cm (0.98 feet) to 1.8 m
(5.91 feet) (Wide)
30 cm (0.98 feet) to 1.0 m
(3.28 feet) (Tele)
ISO200 40 cm (1.31 feet) to 2.6 m
(8.53 feet) (Wide)
30 cm (0.98 feet) to 1.4 m
(4.59 feet) (Tele)
ISO400 60 cm (1.97 feet) to 3.7 m
(12.14 feet) (Wide)
40 cm (1.31 feet) to 2.0 m
(6.56 feet) (Tele)
ISO800 80 cm (2.62 feet) to 5.3 m
(17.39 feet) (Wide)
60 cm (1.97 feet) to 2.9 m
(9.51 feet) (Tele)
ISO1600 115 cm (3.77 feet) to 7.5 m
(24.61 feet) (Wide)
90 cm (2.95 feet) to 4.1 m
(13.45 feet) (Tele)
The available focus range differs
depending on the recording mode.
When you use the fl ash when you
have set ISO sensitivity to [AUTO], ISO
sensitivity automatically becomes a
maximum of [ISO1000]. ([ISO400] in the
[BABY1]/[BABY2] modes and [ISO800] in
the [PET] or [SPORTS] modes)
The edges of the picture may appear
dark if you shoot a very close subject with
the fl ash while the zoom lever is close to
the W side. Zoom in slightly if this occurs.
Available fl ash range varies depending
on ISO sensitivity in [HIGH SENS.].
W: approximately 115 cm (3.77 feet) to
15 m (49.21 feet)
T: approximately 90 cm (2.95 feet) to
8.3 m (27.23 feet)
■
•
•
•
•
–
–
VQT1L50DMC-LS80P-PC.indd40VQT1L50DMC-LS80P-PC.indd40 2007/12/3116:03:472007/12/3116:03:47