262
SQW0740
Wi-Fi
About connections
■
When connecting with [Manual Input]
On the screen of step
1
of “If you are not sure about the WPS compatibility (connecting
by [From List])”, select [Manual Input] (→261)
Enter the SSID of the wireless access point you are connecting to, then select [Set]
• For details on how to enter characters, refer to “Entering Text” (→49)
Select the network authentication type
• For information on network authentication, see the instruction manual of the wireless access
point.
Select the encryption type
• The type of settings that can be changed may vary depending on the details of network
authentication settings.
Network authentication type Encryption types that can be set
[WPA2-PSK] / [WPA-PSK] [TKIP] / [AES]
[Common Key] [WEP]
[Open] [No Encryption] / [WEP]
(When an option other than [No Encryption] is selected)
Enter the encryption key
●
Check the wireless access points instruction manual and settings when saving a wireless access
point.
●
If no connection can be established, the wireless access point’s radio waves may be too weak.
Refer to “Message displays” (→290) and “Q&A Troubleshooting” (→296) for details.
●
Transmission speed may decrease, or may not be usable depending on the environment it is used
in.
To Next Page
Loading...
Need help?
General
