Panasonic minas a series - System Configuration and Wiring; CN I;F Connector

- 38 -
System configutration and wiring
CN I/F Connector
Interface Circuit (Input Circuit)
PI Command pulse
input circuit
1) Line Driver I/F
•
This is a good signal transmission method that is
less sensitive to noises. We recommend you to
use this to maintain the reliability of signals.
2) Open Collector I/F
•
This uses an external control power supply(VDC).
• This requires a current-limiting resistor correspond-
ing to the capacity of the VDC value.
PI
SI Connecting to
se quence input signals
• Connect to a contact of switch and relay, or a tran-
sistor of an open collector output.
• Use a switch or relay for micro current so that
insufficient contact can be avoided.
• Lower limit of the power supply (12 to 24V) should
not be less than 11.4V in order to secure the ap-
propriate level of primary current of the photo cou-
pler.
SI
VDC R value
12V 1kΩ 1/4W
24V 2kΩ 1/4W
12~24V
7
COM+ 4.7K
Servo-ON or
other input
Relay
7 COM+ 4.7K
12~24V
Servo-ON or
other input
AM26LS31or equivalent
3
PULS1
PULS2
SIGN1
SIGN2
GND
220
220
4
5
6
13
PULS1
PULS2
SIGN1
GND
SIGN2
220
220
VDC
R
R
3
4
5
6
13
á@
áA
shows a pair of twisted wires.
VDC - 1.5
R + 220
= 10mA