Panasonic minas a series - Troubleshooting; The motor does not rotate.

- 72 -
Maintenance and Inspections
Replacement Guidance
Parts replacement cycles depend on the actual operating conditions and how the equipment has
been used. Defective parts should be replaced or repaired immediately.
Equipment
Driver
Motor
Part
Smoothing condenser
Cooling fan
Aluminum
electrolytic
capacitor on the
print board
Bearing
Oil seal
Encoder
Battery
(Absolute encoder)
Standard replacement
cycles (hour)
about 5 years
2 to 3 years
(10 to 30 thousand hours)
about 5 years
3 to 5 years
(20 to 30 thousand hours)
5000 hours
3 to 5 years
(20 to 30 thousand hours)
1 year from
the first use
Remarks
The replacement cycles shown here are
just only for reference. If any part is found
defective regardless of the standard re-
placement cycles, immediately replace it
with a new one.
Prohibited
Dismantling for inspections or repairs should be done by our company
(or our sales agents).