Panasonic NV-SD350 - Page 26

{26}
Programming the Video
Plus+ PlusCode
Programming is now easier than ever: simply enter the
PiusCode provided in the programme schedule column
carried by newspapers and magazines.
PlusCodes are numbers which are assigned to each
programme listed in the TV programme schedule carried
in newspapers and TV guides. When these codes are
entered and STORE is pressed, the codes are converted
into the actual programming.
Preparations
einsert a cassette tape with an intact erasure prevention _ .
tab.
Confirm that the TV is on and the VCR viewing channe!
is selected.
Operations
1 Press VIDEO PLUS+-.
oe
# Enter a PlusCode.
&
Example: 920216
Display Symbols
3 Press STORE.
On Screen Display
*Confirm that the programming contents are correct
before setting the VCR to timer recording standby
mode.
®The VCR will be in the timer recording standby
mode after about 1 minute
*if the “-—" appears in the programme position:
select the programme position of your VCR which
receives the TV station you entered at step 2 using
button A or ¥.
*To extend the ending time or to make any
corrections, use buttons & ¥ <4 ® or Av.
_ DATE, ON, OFF.
Notes:
*To release from the standby mode, press TIMER REC.
*When the PlusCode is used for programming, the
recording time may be slightly longer than the actual
programme time.
eWhen programming two or more programmes, repeat
steps 1-3.
The procedures for checking and cancelling a timer
or
programme are the same as on page 25.